UVMTestBuilder™

Generate complete UVM environments automatically from your RTL design in minutes

Quick Start Guide

leducatech.com · getting started with UVMTestBuilder

1. Workflow

1. Create a new project, choosing the directory where it will be created.
2. Click in Create. If the project already exists, you can overwrite it or give it a new name.
3. Click in Select RTL Files and select the RTL files you want to verify, specifying the top module if there is more than one file.
4. These files will automatically be copied into the RTL folder inside the created project
5. Enter the author name and the company name
6. Click in Run UVMTestBuilder.

Note: If the design has more than one clock domain, a dialog box will open when the RTL files are selected, asking you to assign each signal to its corresponding clock domain.

7. If the process completes successfully, a message will indicate that all verification files have been generated inside the project's verif folder. del proyecto.

2. Generated project structure

Once generation is complete, three main folders are created inside the project:

Folder	Contents
RTL folder	Input RTL files, copied when the project is created.
Verif	Complete UVM verification environment, organized into the subfolders described below.
Sim	Simulation scripts: compile.do and run.do.

Subfolders inside Verif

The Verif folder contains the complete UVM verification environment, organized into the following subfolders:

Subfolder	Generated files
/agent	agent.sv, driver.sv, monitor.sv, sequencer.sv, sequence_item.sv, agent_pkg.svh
/env	env.sv, env_pkg.svh, scoreboard.sv, coverage.sv
/ref_model	ref_model.sv, ref_model_pkg.svh
/tb	tb_top.sv, interface.sv
/tests	basic_test.sv, test_lib.svh
/seqs	sequence_lib.svh, basic_seq.sv
/common	param_pkg.sv, tb_param_pkg.sv

3. Next steps

Once the environment has been generated, open the project in QuestaSim using the compile.do script to compile, and run.do {UVMTest_name} script to simulate from the Sim folder.

License Installation Guide

1. Introduction

leducatech.com · technical support and product activation

This document describes the procedure to activate the UVMTestBuilder license on your computer. Activation is performed only once per installation and is tied to the Hardware ID (HWID) of the machine being used.

2. Installation procedure

1. The first time the application is launched, it will request a license through a dialog box from which you can copy the HWID (Hardware ID) of the machine being used.
2. Send this HWID by email to license_info@leducatech.com to request the license.
3. Once the license file is received, save it to a local, accessible directory on your machine.
4. Launch the application again and click the Load Licensebutton. Browse to the saved license file and select it to install it.
5. If the process completes successfully, the following message will appear: “License installed successfully”.

Note: After installing the license, close and relaunch the application to start working normally.

3. Support

If you run into any issues during activation, contact license_info@leducatech.com including the machine's HWID and a description of the problem.